Features:
Power range:7.2V-12V
Input voltage(advise):6-10 cells Ni-MH/Ni-Cd
Weight:60g (including connectors and switches)
BEC:5.6V 2A
Output current:forward 320A
Out of control protection
Low voltage protection
Over-voltage protection
With heat sink for 540 dual motor or single motor
Operating system : forward, reverse, and brake
Operational Guidelines:
1.the right and a power supply battery connection on both ends of the wiring board the red line for positive, black, compared with negative. (Or standard DC battery connection plug Daejeon male plug / T-plug / banana plug)
2.ESC output red and black wire are connected to the red and black lines of the car 540 motor.
3.open the ESC power switch, if no signal input, motor will send a beep ~ beep ~ beep \"alarm sound. Turn the transmitter power signal injection will issue the voice of the duo ~ ~ Mi \", has been connected to prove the transmitted signal and receiving the electrical and mechanical tone.

NOTE: This ESC is recommended for use with Ni-Cd, Ni-Mh or SLA batteries, these are not recommended for Li-Po batteries as the high discharge rate will cause failure